Featured

5pcs CJMCU-832 PAM8302 2.5W Single Channel Class D Audio Power Amplifier Module Mono Amplifier

5pcs CJMCU-832 PAM8302 2.5W Single Channel Class D Audio Power Amplifier Module Mono Amplifier
Click image for Gallery
  • Product Code: FZ3420X5-PAM8302 2.5W Audio Amplifier
  • Availability: In Stock
  • $8.99
  • Ex Tax: $8.99
  • Price in reward points: 2
  • 2 or more $7.99
  • 5 or more $6.50
  • 10 or more $5.50
- +



Tags: PAM8302, Audio Amplifier, CJMCU-832

Description:

This super small mono amplifier is surprisingly powerful - able to deliver up to 2.5 Watts into 4-8 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.0V-5.5VDC. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over half a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. There's even a volume trim pot so you can adjust the volume on the board down from the default 24dB gain. This board is a welcome upgrade to basic "LM386" amps!

The A+ and A- inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the Audio- pin  to ground. The output is "Bridge Tied" - that means the output pins connect directly to the speaker pins, no connection to ground. The output is a high frequency 250KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly.

Comes with a fully assembled and tested breakout board. We also include header to plug it into a breadboard and a 3.5mm screw-terminal blocks so you can easily attach/detach your speaker. You will be ready to rock in 15 minutes! 

Speaker is not included, use any 4 ohm or greater impedance speaker.


Parameter:

  • Output Power: 2.5W at 4Ω, 10% THD, 1.5W at 8Ω, 10% THD, with 5.5V Supply

  • 50dB PSRR at 1KHz

  • Filterless design, with ferrite bead + capacitors on output.

  • Fixed 24dB gain, onboard trim potentiometer for adjusting input volume.

  • Thermal and short-circuit/over-current protection

  • Low current draw: 4mA quiescent and 1uA in shutdown mode


Package included:

5 X  PAM8302 2.5W Audio Amplifier


Write a review

Note: HTML is not translated!
    Bad           Good

Related Products