MotoMama L298N H-Bridge DC Motor Stepper Driver Chip Shield Starter Kit For Arduino Motor And Robot Project
MotoMama is a shield based on L298N H-bridge driver chip.
You can use this shield to drive two DC motors or an four-wire two-phase stepper motor. For power supply , power terminal on board is available – it will also power the board. Or from the power jack on board, the shield will get the power form the Vin pin and derive the motor using this power.
In many motor and robot project, you need to use the wireless communication, so on board we build a wireless area. Now you can directly put a XBee (or other XBee pins compatible module, like BTBee) and a nRF24l01 module on the board.
We layout the reset pins which not be used for LN298 and wireless on board, and they are all the AD pins , so you can use this pins as the sensor input or output.
We hope this design can be used as the motherboard of many small motor or robot project, because it has enough resources for wireless communication, sensor data acquisition and some simple control, so we name it “MotoMama” : ) , not Motorola.
MotoMama not only can be used as a UNO or IFLAT shield, but also can be used as a DC driver platform, so we didn't emsamble the pins on board, so that it will have more applicability - using the positioning hold on board, you can fix it on your robot chasis.
1 X MotoMama assembled board
2 X 2.54 40PIN Male Header
2 X 2.54 8PIN Female Header
2 X 2.54 6PIN Female Header
1 X Stackable header kit