1.54inch E-Ink Display Module Type A Black/white Two colors e-Paper Module 200X200 Resolution SPI Interface for Raspberry Pi Support Partial Refresh FZ3047

Description:

This is an E-Ink display module, 1.54inch, 200x200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.
Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.

Features

    No backlight, keeps displaying last content for a long time even when power down
    Ultra low power consumption, basically power is only required for refreshing
    SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
    Onboard voltage translator, compatible with 3.3V/5V MCUs
    Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

    Operating voltage: 3.3V/5V
    Interface: 3-wire SPI, 4-wire SPI
    Outline dimension: 48mm × 33mm
    Display size: 27.6mm × 27.6mm
    Dot pitch: 0.138 × 0.138
    Resolution: 200 × 200
    Display color: black, white
    Grey level: 2
    Partial refresh time: 0.3s
    Full refresh time: 2s
    Refresh power: 26.4mW(typ.)
    Standby power: <0.017mW
    Viewing angle: >170°

Interface

SYMBOL     DESCRIPTION
VCC     3.3V/5V
GND     Ground
DIN     SPI MOSI pin
CLK     SPI SCK pin
CS     SPI chip selection, low active
DC     Data/Command selection (high for data, low for command)
RST     External reset, low active
BUSY     Busy status output, high active

Package included:

1 X 1.54inch e-Paper Module
1 X 8Pin PH2.0 cable 20cm