ADXL345 Digital Accelerometer Module IIC/SPI 3-Axis Inclination Tilt Sensor with 10Pin Female to Female/Female to Male Dupont Cable for Arduino Raspberry Pi (Pack of 2)

ADXL345 Digital Accelerometer Module IIC/SPI 3-Axis Inclination Tilt Sensor with 10Pin Female to Female/Female to Male Dupont Cable for Arduino Raspberry Pi (Pack of 2)
Click image for Gallery
  • Product Code: FZ0085X2+FZ0035C+FZ0036C ADXL345 Digital Accelerometer
  • Availability: In Stock
  • $10.99
  • Ex Tax: $10.99
  • Price in reward points: 2
  • 2 or more $9.99
  • 5 or more $8.99
- +



Tags: ADXL345, Digital Accelerometer, Acceleration Module, Inclination Tilt Sensor

Description:
The ADXL345 is low power, high resolution 13bit, 3-axis accelerometer Digital output, accessible through both SPI (3 or 4-wire) or I2C interface (formatted as 16-bit twos complement).
ADXL345 will measure static acceleration and tilt as well as High G dynamic acceleration (motion or shock)
13 Bit resolution allows for inclination change measurements < 1.0° (4 mg/LSB)

ADXL345 will detect:
motion or lack of motion
acceleration on any axis exceeding user-defined level
acceleration threshold sensing
acceleration up to ±16 g
Single or Double tap sensing (1 or 2 mouse clicks)
Free-fall sensing
motion mappable to one or two interrupt outputs

Specifications:
2.0-3.6VDC Supply Voltage
0.1uA @ 2.5V, 40uA in normal mode
SPI / I2C interfaces

Female to Female cable is for ADXL345 with MCU which is onboard male pin header like Raspberry Pi board
ADXL345 wiring with RPi board: 3V3--3.3V, GND--GND, SDA--GPIO2, SCL--GPIO3.
Female to Male cable is for ADXL345 with MCU which is onboard female header such as UNOR3board.
ADXL345 wiring with UNOR3board: 3V3--3.3V, GND--GND, CS--Pin#10, SDA--Pin#11, SDO--Pin#12, SCL--Pin#13.

Package Included:
2 X ADXL345 Digital Accelerometer Sensor Module
1 X 10P 2.54mm Female to Female Dupont Cable 20cm
1 X 10P 2.54mm Female to Male Dupont Cable 20cm

Write a review

Note: HTML is not translated!
    Bad           Good

Related Products