1.5inch OLED Display Module White SSD1327 128x128 SPI I2C interface 3.3V-5V for Arduino Raspberry Pi STEM32 16 Gray Scale FZ3324

Description:

This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.
Features

    128x128 high resolution
    16 gray scale, better display effect
    Supports SPI or I2C interface, configured via onboard resistor
    Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications:
    Driver: SSD1327
    Interface: SPI / I2C
    Display color: White
    Gray scale: 16
    Resolution: 128x128 (most other competitive products are typically 128x64)
    Viewing angle: >160°
    Operating voltage: 3.3V / 5V
    Dimension: 44.5 x 37 (mm)

Interface:
SYMBOL     DESCRIPTION
VCC     Power (3.3~5V input)
GND     Ground
DIN     Data input
CLK     Clock data input
CS     Chip selection, low active
DC     Data/Command selection (high for data, low for command)
RST     Reset, low active

There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:
      BS     CS     DC     DIN     CLK
4-wire SPI     0     Chip select     Data/Command     MOSI     SCK
I2C     1     NC     I2C address selection     SDA     SCL

Package Includes:
1 X 1.5inch OLED Display Module
1 X PH2.0 7P dupond cable