ESP32-C3-DevKitM-1 Development Board Equipped with with ESP32-C3-MINI-1 Wifi Bluetooth-compatible Module with 4MB ESP32-C3FN4 Flash chip FZ5168

ESP32-C3-DevKitM-1 Development Board Equipped with with ESP32-C3-MINI-1 Wifi Bluetooth-compatible Module with 4MB ESP32-C3FN4 Flash chip FZ5168
Click image for Gallery
  • Product Code: FZ5168-ESP32-C3-DevKitM-1 Development Board
  • Availability: In Stock
  • $21.99
  • Ex Tax: $21.99
  • Price in reward points: 3
  • 2 or more $19.99
  • 5 or more $18.50
  • 10 or more $17.50
- +



Tags: Espressif, ESP32-C3, ESP32-C3-DevKitM-1, Development board, ESP32-C3-MINI-1, ESP32-C3FN4 4MB Flash chip

General:
ESP32-C3-DevKitM-1 is an entry-level development board based on ESP32-C3-MINI-1. This board integrates complete Wi-Fi and Bluetooth LE functions.

Components Descriptions:
ESP32-C3-MINI-1:
ESP32-C3-MINI-1 is a general-purpose Wi-Fi and Bluetooth LE combo module that comes with a PCB antenna. At the core of this module is ESP32-C3FN4, a chip that has an embedded flash of 4 MB. Since flash is packaged in the ESP32-C3FN4 chip, rather than integrated into the module, ESP32-C3-MINI-1 has a smaller package size.

5V to 3.3V LDO:
Power regulator that converts a 5 V supply into a 3.3 V output.

5V Power On LED:
Turns on when the USB power is connected to the board.

Pin Headers:
All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board. For details, please see Header Block.

Boot Button:
Download button. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port.

Micro-USB Port:
USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-C3FN4 chip.

Reset Button:
Press this button to restart the system.

USB-to-UART Bridge:
Single USB-UART bridge chip provides transfer rates up to 3 Mbps.

RGB LED:
Addressable RGB LED, driven by GPIO8.


Power Supply Options:
There are three mutually exclusive ways to provide power to the board:
    Micro-USB Port, default power supply
    5V and GND pin headers
    3V3 and GND pin headers
It is recommended to use the first option: Micro-USB Port.

How to install ESPC3 in arduino IDE?
1, click File-Preference, and copy below links to "Arduino Preferences Additional Boards Manager URLs", then click "OK".
https://raw.githubusercontent.com/espressif/arduino-ESP32/gh-pages/package_ESP32_dev_index.json
2, Tools-Board-Boards Manager-ESP32, you need download 2.0.0 version, (any version over 2.0.0 is ok)

Package Included:
1 X ESP32-C3-DevKitM-1 Development Board with ESP32-C3-MINI-1 module

Write a review

Note: HTML is not translated!
    Bad           Good

Related Products