ESP32 Programming Module, ESP-WROOM-32 Test Board Firmware Burning Fixture, Micro USB interface CP2102 Chip FZ3511

This is ESP32 burning fixture, makes the ESP32 programming very easy and simple. Support for ESP-23/ESP-32D/ESP-32U etc.
Kindly note that it only works with SMD chips/chip module, can not work with implementing whole module like NodeMCUs or other ESP32 development board.

How to program?
1, Download the flash tool from espressif and also install CP2102 driver if you haven't install it before. Here is the link for the Flash Download Tools: https://www.espressif.com.cn/en/support/download/other-tools
2, Open the flash download tool, and choose ESP32. Fill in the bin file address in SPIdownload.
3, The Flash config will be filled automatically, no need to choose. If not due to different version, you need set the flash config firstly.
4, Choose the COM port, and baud rate. If the baud rate you choose too big, you may fail to flash, in this case, you need choose a small baud rate.
5, Click "Start", and it starts to flash. If you failed to flash it, pls click "Stop" firstly, and check for baud rate, then re-click "Start".
Note: Please make sure the chip module is seated properly in the programmer before you flash the new firmware!


Package included:
1 X ESP32 Programming Module Burning Fixture