GY-6500 MPU-6500 Acceleration Sensor MPU6500 I2C 6DOF 6-Axis Gyroscope Accelerometer Sensor Module for Arduino UnoR3 FZ1056C (Pack of 5pcs )

GY-6500 MPU-6500 Acceleration Sensor MPU6500 I2C 6DOF 6-Axis Gyroscope Accelerometer Sensor Module for Arduino UnoR3 FZ1056C (Pack of 5pcs )
Click image for Gallery
  • Product Code: FZ1056CX5-MPU-6500 I2C Acceleration Sensor
  • Availability: In Stock
  • $12.99
  • Ex Tax: $12.99
  • Price in reward points: 2
  • 3 or more $11.99
  • 10 or more $10.99
- +



Tags: GY-6500, MPU-6500, MPU6500, Acceleration Sensor, Accelerometer Gyro Sensor


Note: the original supplier of GY-6500 MPU6500 Accelerometer Gyro sensor module stopped production, this listing is for the copied board by other factory.
There are two similar board, one is with mark MPU-9250/6500, and the other with mark MPU92.65. Recently test the two board, and found MPU92.65 not function well, while MPU-9250/6500 works.
You can find the test result in pictures that i made for these two boards.

Specification:
MPU-6500 6ODF modules: three-axis gyroscope + triaxial accelerometer
Chip: MPU-6500
Power supply: 3-5V (internal low dropout regulator)
Communication: Standard IIC / SPI communication protocol
16bit AD converter-chip 16-bit data output
Gyro range: ± 250 500 1000 2000°/ s
Acceleration range: ± 2 ± 4 ± 8 ± 16g
Using Immersion Gold PCB, machine welding process to ensure quality
2.54mm pin spacing
Module size 15mm * 25mm

Connection:
MPU-6500 Acceleration Sensor --> Arduino UNOR3 development board
VIN --> 5V
GND --> GND
SCL --> A5 / SCL
SDA --> A4 / SDA

How to test the I2C address for MPU-6500 Acceleration Sensor?
Follow above connection to wire the MPU6500 with UNOR3 board, and then connect the UNOR3 to the computer via USB cable.
Open your arduino IDE, and go to the File-->Examples-->Wire-->i2c_scanner.
Choose board and COM port in Tools before you upload. And then you will get the i2c address 0x68 when you open Serial Monitor.
Note: if the test result is that i2c device not found, it very likely means that the board you got not work well.

How to test the MPU-6500 Acceleration sensor with arduino UNOR3?
1, Install library if you don't have it, like MPU-9250 or MPU-6050.
Go to the Tool-->Manage libraries-->search MPU6500, and install MPU9250_WE
2, Go to the File --> Examples -->MPU9250_WE-->MPU6500_all_data
3, Go to the Tool, choose the board and COM port.
4, Upload the code.
5, Open the Serial Monitor, choose the baud rate matching the one in the code, should be 115200, and you will get the output data.
If the baud rate is not matching, the output data maybe not correct and not readable.

Package Included:
5 X MPU6500 6-Axis Accelerometer Gyroscope Sensor Module (Pin header not soldered)
1 X 20Pin Male to Female Dupont Cable

Write a review

Note: HTML is not translated!
    Bad           Good

Related Products