This is a super mini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip.
Solar charger provide you with the ability to get the most possible
power out of your solar panel or other photovoltaic device and into a
rechargeable LiPo battery.
Set-up is easy as well, just plug your solar
panel into one side of the Solar charger and your battery into the other
and you are good to start charging!
The output of the Solar
Charger is intended to charge a single polymer lithium ion cell. The
load should be connected in parallel with the battery.
By default, the
Solar charge comes set to a maximum charge current of 500mA with a
maximum recommended input of 6V (minimum 4.4V). It’s recommended that
batteries not be charged at greater than their capacity rating.
Solar panel input: 4.4-6V
Max charge current: 500Ma
Interface: 2-pin JST connectors(or PH2.0)
Short circuit protection
Continuous Charge Current Up to 500mA
Battery status indication (Red : Charging , Blue: Charged)
Size: 2cm x 4cm
5 X CN3065 Mini Solar Lipo Charger Board